This is a journey into sound...

So I decided to try and get some sound out of my Vocore tiny linux box. It doesn’t come with any audio support, so I decided to add a USB sound card. I bought one of these, which I knew worked on the Raspberry Pi, so I knew had Linux support. They’re also pretty small:

I simply followed these instructions describing how to add USB Audio support to OpenWrt. At first, I chose to install sox as the player (I originally intended to use Madplay, but I don’t think it is supported on current versions of OpenWrt anymore).

I did not have much success playing mp3 files straight away, I kept getting sox WARN alsa: under-run messages when I tried to use the following command:

sox myfile.mp3 -d

Although sound was coming out … in chunks, so it was a partial success. But when I added a “-G” parameter to use temporary files (supposed to guard against clipping) like this:

sox myfile.mp3 -d -G

…then it worked fine for some lower quality mp3 files, but with a considerable delay before playing anything out the speaker. If I tried to play some better quality mp3 files then it was still stuttery. So then I started to experiment with reducing the sound quality, which sox can do easily. So I tried this:

sox myfile.mp3 -r 8000 -e unsigned -b 8 -c 1 test.raw

…which results in a raw file that can be played with the aplay command that comes with the ALSA soundcard drivers (specifically, the command above gives mono unsigned 8 bit with a rate of 8000 Hz). Whilst this results in a poor quality file, I found that the Vocore would happily play these raw files. In some ways it was kinda cool to hear my original mp3 file playing with a hiss in the background. But then I decided to see what happens if I create a file in “CD” quality, so I tried this:

sox myfile.mp3 -r 44100 -e signed -b 16 -c 2 test.raw trim 0 00:30

Note, that to save space on the Vocore I used the trim parameter to just convert the first 30 seconds. Playing that “CD” quality file on the Vocore also worked perfectly, with this command:

aplay test.raw -f cd

Passing the parameter -f cd means 16 bit little endian, 44100 Hz, stereo and is the same as passing -f S16_LE -c2 -r44100. Here’s a screenshot of a CD quality raw file playing on the Vocore with the aplay command.

So… what I’m doing now is using sox on another Linux box to convert the mp3 files and then just using aplay on the Vocore to play them. It should mean that sox is not actually required on my Vocore. It also means that playback is immediate and the quality is good. I will need to find a means to store the files, because they’re much bigger than mp3, but that’s a problem for another day… I’ll probably see if I can mount a USB stick or something.